download PDF

Abstract

The article describes a method for sensorless determining of rotor angular position in a synchronous motor by means of superimposing a high frequency signal. The scheme of the laboratory bench for the experiment is described. A formula for rotor angular position calculation of a synchronous motor was developed. It was concluded that the developed method makes it possible to reduce the cost and the size of the system for determining the angular position and increase its reliability.

Keywords

Sensorless control, high frequency injection, synchronous machine.

Baskov Sergey Nikolaevich – Ph.D. (Eng.), Associate Professor, Applied Computer Science and Control Systems Automation Department, «National Research Technological University «MISIS», Novotroitsk branch, Novotroitsk, Russia. E-mail: This email address is being protected from spambots. You need JavaScript enabled to view it..

Litsin Konstantin Vladimirovich – post-educate student, Nosov Magnitogorsk State Technical University, Magnitogorsk, Russia. E-mail: This email address is being protected from spambots. You need JavaScript enabled to view it..

1. Baskov S.N., Litsin K.V., Princip vectorno-impulsnogo upravleniya electrodvigatelyami peremennogo toka [Vector-pulse principle to control AC motors]. Vestnik YuURGU. Seriya energetika [Bulletin of South-Ural state university. Power engineering]. 2013, vol. 13, no. 1, pp. 92- 95.

2. Baskov S.N., Konkov A.S., Cherkas T.V., Litsin K.V. Issledovanie polozhenija vektora potokosceplenija rotora pri vektorno-impul'snom puske [Study of rotor flux linkage vector in vector-pulse start]. Vestnik YuURGU. Seriya energetika [Bulletin of South-Ural state university. Power engineering]. 2012, vol. 18, no.37, pp. 68-72.

3. Baskov S.N., Litsin K.V. Vysokochastotnaja inzhekcija signalov pri bezdatchikovom metode opredelenija uglovogo polozhenija rotora [ High-frequency signal injection in sensorless method for determining the angular position of the rotor]. Elektronnii zhurnal «Mashinostroenie» [Electronic Journal «Engineering»]. 2013, no.1, pp.28-34 (available at: http://www.indust-engineering.ru/issues/2013/2013-1.pdf).

4. O. Goksu. Shaft transducerless vector control of the interior permanent magnet motor with speed and position estimation using high frequency signal injection and flux observer methods," Master's thesis, The Graduate School of Natural and Applied Sciences of Middle East Technical University, May 2008.

5. Persson Jan. Innovative standstill position detection combined with sensorless control of synchronous motors. Lausanne, Switzerland.: École polytechnique fédérale de Lausanne (EPFL), 2005.

6. Busca Cristian. Open loop low speed control for PMSM in high dynamic application. Aalborg, Denmark.: Aalborg universitet, 2010.

7. Vas Peter. Sensorless vector and direct torque control. Oxford, UK.: Oxford University Press, 1998.

8. Sun Don, He Yikang, Zhi Dawex. Direct torque control of synchronous motor with permanent magnets based on fuzzy logic // Trans. China Electrotech. Soc, 2003, № 1, p. 33- 38.